It's been a while since I have given an update on progress. Mostly, the progress hasn't been anything too exciting, or exciting enough to write about, but I figured I should anyways. So last time I left off I had made the doors and and had begun to scrape all the glue lines for the top. I have since then finished all the scraping; I had to scrape the bottom platform and all the side pieces...basically anything that I had joined. Next I turned my attention to the two swing out doors. These are for holding games and DVD's. To keep things simple, and looking good, I decided to go with half-blind dovetails to joint the sides to the bottom (there is not top). So I set it all up in my Leigh jig, made a couple test cuts and knocked them out.
I had a little tear out on the first one because I forgot to use a backer board. This joint is on the bottom anyways so it will never be seen.
Next, I figured I would start on the top. It takes a while to glue the boards up so I figured now was a good time to do it because while the glue dries I can work on other items. So, the top is to be about 65" long by 22" deep. I started with a long 12/4 piece of wood. This I will resaw three times to get my three pieces need to make the top. I have an 8" jointer and this board was wider than that so I had to initially flatten it by hand. For those not familiar with doing this, a good way to get started is to use chalk and mark up your board.
This allows you to know the areas that you have, and have not, planed. Then, you use something like a #4 and begin to work up and down the board at a pretty big angle, somewhere between 45 and 60 degrees.
This is a shot of about half way though. You can see the center of the board still has chalk, this tells me that I have not yet gotten the whole thing flat. If you look at the part of the board closest to you, you can also see the plane marks and the angle of approach I am using. As you get it more and more flat, you begin to decrease the angle and then eventually switch to another plane to finish it off.
Here are the three, book matched, boards after being resawn and planed to thickness. By the way, resawing a 12/4 piece of wood 70" long is a real treat!
It's not the greatest picture in the world, but I think you can get an idea for the triple book match. This is something that sets one piece of work apart from others so take note when looking at "antique" furniture and the quality of work.
Next, I needed to layout and begin routing the dado's for the vertical panels. I'm starting with the two outer most panels, these only come in just over half way as they are part of the swing out door assembly. I always turn into a nervous wreck when I have to do things like this because if you mess it up, all that wood and work are ruined. Anyways, I made the first two with no problem.
So next I need to rout the dado's in the swing out doors that house the shelves for the storage. This will be two dado's on each side. Once I have those in, I will then glue up the swing out doors and use those to aid me in laying out where the next dado's go for the middle, full length, vertical panels. More on that later though!
Be safe!
